36W PRO Gel Acrylic Curing UV Lamp Nail (take in and out)

Installation:

1, The windows of Ultraviolet Radiation Lamp shall face to the front of the user

2, Connect the power line plug into the electric socket

Operation:

1, Press the power switch to ON or "L", the indicator LED of time start switch is lighten.

2, Press the delay switch to 120secs, press the time start switch, all of the Ultraviolet Radiation Lamp are on, all machine in work

3, Put the band into the region of lamp, until 120secs, all of the Ultraviolet Radiation Lamp are off.At the same time, the process of dryness and sterilzation are finished.

4, Press the Delay Switch to "time", Ultraviolet Radiation Lamp are on, the time is infinite.At the same time,press the power Switch to OFF or "O", the machine stop working.

5, When the Delay Switch at "time", Ultraviolet Radiation lamp work in the infinite then press the Delay switch to "120 sec", the LED lamp lighten still,but the machine will into delay estate again.The time to 120secs, the Ultraviolet Radiation lamp off.

6, Press the power switch to OFF or "O", the power closed and 120S/     the machine stop working.

Specification:

1, Rated voltage range: 110~120V; 220~240V  50/60Hz

2, Rated power: 36/42/45W

3, Rated current: 0.2~0.35A

4, Working Temperature: -15℃ ~ 50℃

Instructions:

1, Please accord the rated voltage with the machine, or else it is easy to make the machine broken

2, Please no try to plug out the power line when the machine in work, unless you close the power switch.

3, Don't make the water and sundries and so on into the machine, or else the machine will stop running as normal.

4, Use the wet cloth and litmusless scour to sweep the dirty in the surface of machine.Please pay attention to close the power switch.

5, Please plug the power line out of electric socket, if you don't use in a long time.

6, Any unauthorized disassembling of the product is prohibited. In case of any break down, please contact the agent or authorized repair center. We promise wise, high-quality and satisfactory service.

7, If the supply cord is damaged, it must be replaced by the manufacture, its service agent or similarly qualified persons in order avoid a hazard.